Page 1 of 1
wadefish help
Posted: Sun Jan 24, 2010 2:13 pm
by mike40
Hello,
so I purchased the plans for the wadefish about a year ago and I have all the panels cut out....just now starting to put everything together. Where on the plans is the string alignment method? I see the "QA2" drawing mentioned often in these posts but my plans have nothing labeled as such...what am I missing?
Mike
Re: wadefish help
Posted: Sun Jan 24, 2010 4:35 pm
by jem
Should be in the assembly instruction.
Re: wadefish help
Posted: Sun Jan 24, 2010 5:07 pm
by mike40
Ive looked...do you have a page #? I have instruction pages.. 1-47 plus sheet 1.1-1.4, 3.1-3.3, 4.1-4.2, nesting sheet, sheet 2, reference sheet, scupper drawing...am I missing any?
Re: wadefish help
Posted: Sun Jan 24, 2010 5:09 pm
by mike40
page 6 shows how to do it but no measurements..
Re: wadefish help
Posted: Sun Jan 24, 2010 5:11 pm
by jem
Use the measurements from the QA2 drawings.
Re: wadefish help
Posted: Sun Jan 24, 2010 5:38 pm
by mike40
nothing says "QA2 drawing"...from the pages I listed in the above posts. did I lose a page? or am I just an idiot and can't see the trees because of the forest....
Re: wadefish help
Posted: Sun Jan 24, 2010 6:04 pm
by jem
oh! I missed that part. Shoot me an email and I'll get that to you right away.
Re: wadefish help
Posted: Tue Jan 26, 2010 8:08 am
by mike40
email has been sent...thanks
Re: wadefish help
Posted: Tue Jan 26, 2010 4:54 pm
by jem
replied with attachment!
