Page 1 of 1
Laker 18 A Cuda 2
Posted: Tue Jun 30, 2009 11:23 pm
by tx river rat
Here we go again. tomorrow back to the box store for wood.
Ron
Re: 18 A
Posted: Wed Jul 01, 2009 9:15 am
by jbo_c
Are there drawings? I went through the other post and couldn't decide what this was. If I understand, it's an extension of some design. Which one?
Jbo
Re: 18 A
Posted: Wed Jul 01, 2009 9:29 am
by jem
It's pretty much a Laker except that is asymmetrical (from a top view: the max beam is shifted aft a little for a "Swede Form" hull) and Ron is doing his own deck design.
The Bow and stern heights were also lowered per Ron's request. It's a pure flat water racer that should turn out to be pretty dang fast.
Re: Laker 18 A Cuda 2
Posted: Wed Jul 01, 2009 10:44 am
by tx river rat
Matt
Do you have any ideal where the seat should be mounted. I noticed in the other boats that are asymmetrical it takes a farther back seating position.
Ron
Re: Laker 18 A Cuda 2
Posted: Wed Jul 01, 2009 11:18 am
by jem
You'll want your hips about 19" forward of #4 station. Hope that makes sense.
Re: Laker 18 A Cuda 2
Posted: Wed Jul 01, 2009 4:01 pm
by LIGHT KEEPER'S KID
Ron i hate to tell u.but u need to go the Doc u've got it BAD
it loks like your building so many boats that i can't keep tract
Mike
Re: Laker 18 A Cuda 2
Posted: Wed Jul 01, 2009 11:26 pm
by tx river rat
Mike
I am going to combine several boat ideals into the WTV and build this boat to play with,just two going.
Ron
Re: Laker 18 A Cuda 2
Posted: Thu Jul 02, 2009 8:05 am
by LIGHT KEEPER'S KID
Oh,just two
i can't get one started
Mike