Quetion #972
-
Darrells
- Posts: 347
- Joined: Wed Oct 22, 2008 10:20 pm
- Type of boat I like: <-- Please read instructions to the left and delete this text. Then, tell us what type boat you like! :-)
- Location: Lorena,texas
Quetion #972
Finished putting graphite on my Pirogue. Have a couple of rough spots on the waterline. If I sand them smoothe can I recoat with plain epoxy to restore shine or do I need to add graphite to it?
Darrell Sykora
-
jem
- Site Admin
- Posts: 4916
- Joined: Fri Jun 18, 2004 8:14 pm
- Type of boat I like: Wooden
- Location: Greensboro, NC
- Contact:
Re: Quetion #972
epoxy would do it. Or just sand all the graphite. Messing but makes it very slippery.
-Matt. Designer.
-
Kayak Jack
- Design Reviewer
- Posts: 1186
- Joined: Sun Jun 20, 2004 8:03 pm
- Type of boat I like: <-- Please read instructions to the left and delete this text. Then, tell us what type boat you like! :-)
- Location: South-central Michigan
Re: Quetion #972
Darrells,
You'll like the effects of the epoxy. It will go through lilly pads and such with almost no extra drag at ll. And, the graphite enriched epoxy is much harder than the standard stuff.
You'll like the effects of the epoxy. It will go through lilly pads and such with almost no extra drag at ll. And, the graphite enriched epoxy is much harder than the standard stuff.
Kayak Jack
Doing what you like is FREEDOM
Liking what you do is HAPPINESS
I spent most of my money on whiskey and women - and I'm afraid I just wasted the rest.
Doing what you like is FREEDOM
Liking what you do is HAPPINESS
I spent most of my money on whiskey and women - and I'm afraid I just wasted the rest.