JEM Watercraft

[img]http://i469.photobucket.com/albums ... .jpg[/img]

[img]http://i469.photobucket.com/albums ... .jpg[/img]

OK now onto the strip panels
[img]http://i469.photobucket.com/albums ... .jpg[/img]

[img]http://i469.photobucket.com/albums ... .jpg[/img]

[img]http://i469.photobucket.com/albums ... .jpg[/img]

[url][/url]

feels like I'm making real progress now.this is the template panel version all goopied and had a good sanding today, pics taken before sanding & sanding[url][/url]

[img]http://i469.photobucket.com/albums ... .jpg[/img]

[url][/url]

today lower panels glassed and an end pour done.




[url][/url]

the strip panel version was goopied yeterday( covered in masking tape and newspaper) to avoid the "OhS****

[img]http://i469.photobucket.com/albums ... .jpg[/img]

Now uncloaked to reveal the pre glassed inner panel all goopie

[img]http://i469.photobucket.com/albums ... .jpg[/img]

[url][/url]

the pionty area's fore and aft subject to grounding were reinforced with a chopped fibre goopie mix which i found easy to apply and stays where put with no sagging. Did get a little ragged when removing masking borders but easily pats back down. [img]http://i469.photobucket.com/albums ... .jpg[/img]


[url][/url]

[url][/url]

Only a little progress to show today,last 2 upper panels installed and goopied. [img]http://i469.photobucket.com/albums ... .jpg[/img]



Are those hot pink ties sexy or what. [img]http://i469.photobucket.com/albums ... .jpg[/img]





rest of day sanding ply boat ready for rest of glass inside, no pics no fun.

Looking good!!!