Stanley

[jem]

Strong back almost ready. Shed needs some organization.

[tx river rat]

Hummmmmmmmmmmm
What have you been up to Mat?
Ron

[Oldsparkey]

Hummmmmmmmmmmm
What have you been up to Mat?
Ron

My exact thoughts Ron..............

Chuck.

[jem]

Hummmmmmmmmmmm
What have you been up to Mat?
Ron

Getting back in the game, boys.

[jem]

Getting the panels laid out.

When I picked up the plywood I had them rip the plywood lengthwise up the middle. When I drew up the plans I made sure all the parts were nested to 24 x 96" sheet. The angle of the camera make the below sheets look short but trust me they are full length.



Also invested in a Starret T-24 aluminum T-square. Very nice and easy to work with. Got mine from http://www.toolbarn.com/

[jem]

Can't say enough for these blades. Very clean cutting. Note that the teeth are not slanted up or down. Just perpendicular like a Japanese pull saw.

[jem]

Getting all the parts cut out.

[Wannabe]

Matt,
From looking at the curves on the panels this is not going to be a GrandFather Clock. Am I Hot or Cold? Is it something we have seen before, Hot or Cold? It it something New, Hot or Cold?
Bob
PS. And Who or What is Stanley

[OnkaBob]

PS. And Who or What is Stanley

I reckon it's Stanley Kubrick - which means it's going to look like something out of either "2001 A Space Odyssey" or "A Clockwork Orange".

That's a great idea nesting the panels into half sheets - it will make transport and handling of the ply much easier.

[jem]

Matt,
From looking at the curves on the panels this is not going to be a GrandFather Clock. Am I Hot or Cold? Is it something we have seen before, Hot or Cold? It it something New, Hot or Cold?
Bob
PS. And Who or What is Stanley

1) No tickity toc
2) I'm sure everyone here has seen a wooden boat before. But it's a new design.
3) The name "Stanley" is a play on the style of "craft" this was design was inspired by.