Sasquatch in the Ozarks

[zeb]

Awesome

[LesForgue]

Thanks for the kind comments.

Les , The top panel of this canoe is on a pretty good angle. Both gunwales are flat against the plywood panel. This picture should show what I mean. The canoe is upside down right now while I work on the bottom, but I held the camera upside down under it to get this picture.

...

THANKS TERRY ... I MUST SAY YOU ARE A WOODWORKER PAR EXCELLENCE..

[tw541]

This canoe kind of got put on the backburner for a while. We have been trying to finish up a big remodeling project and build my wife an art studio at the same time. I have recently gotten a little more done. I am pretty much finished with the outside. I decided to go with paint on the bottom.









I still need to install thwarts and seats, and varnish the inside. The plans call for two thwarts for this canoe, and I am undecided where they need to go. I am concerned that wherever I put them will be in the way of the seats final location. We have used pirogues in the past but this will be our first tandem boat. I am unsure of the seat placement. I will use temporary seats until we decide where they need to be permanently.

I have read in a popular canoe building book that the rear seat should be as far back as possible. I would prefer to sit in the back, but I outweigh my wife by about 100 lbs, and it may be hard to trim the canoe. I know how to calculate the seat placement to balance the boat, but I haven't figured how to make it work with me in the back, unless I am closer to the center.

The thwart placement is what has me most concerned. I may try to come up with some moveable thwarts to use temporarily until I decide on a permanent placement.

[Oldsparkey]

"WOW" Terry you sure out did yourself , that is one Good Looking Canoe.

Chuck.

[jem]

second what Chuck said. Nice! Love those "tiger stripes" in the wood.