Ooooh-kay, strip, stitch AND glue. It was the 'at' @ that threw me a bit, as opposed to SS&G. Thanks for the clarification fellas. Sounds like a good method. More information to be stored in the dark recesses of the mind, for future use
Sure is looking good Ron.
SS@G Northwind
-
tx river rat
- Posts: 989
- Joined: Wed Feb 21, 2007 10:48 pm
- Type of boat I like: <-- Please read instructions to the left and delete this text. Then, tell us what type boat you like! :-)
- Location: Tx
Re: SS@G Northwind
Matt
Are the two North winds turning out like you thought they would?
Ron
Are the two North winds turning out like you thought they would?
Ron
-
tx river rat
- Posts: 989
- Joined: Wed Feb 21, 2007 10:48 pm
- Type of boat I like: <-- Please read instructions to the left and delete this text. Then, tell us what type boat you like! :-)
- Location: Tx
Re: SS@G Northwind
Well got my epoxy and glass in today 
Time to start back on the wind.
Matt
Where is the center of balance on this boat?
Ron
Time to start back on the wind.
Matt
Where is the center of balance on this boat?
Ron
-
tx river rat
- Posts: 989
- Joined: Wed Feb 21, 2007 10:48 pm
- Type of boat I like: <-- Please read instructions to the left and delete this text. Then, tell us what type boat you like! :-)
- Location: Tx
Re: SS@G Northwind
I havent got any seams.
Ron
-
jem
- Site Admin
- Posts: 4916
- Joined: Fri Jun 18, 2004 8:14 pm
- Type of boat I like: Wooden
- Location: Greensboro, NC
- Contact:
Re: SS@G Northwind
oh crap that's right.
Ok I'll have to get you a measurement tonight.
Ok I'll have to get you a measurement tonight.
-Matt. Designer.
-
tx river rat
- Posts: 989
- Joined: Wed Feb 21, 2007 10:48 pm
- Type of boat I like: <-- Please read instructions to the left and delete this text. Then, tell us what type boat you like! :-)
- Location: Tx
Re: SS@G Northwind
I think this will be my nicest looking boat. If you havent noticed this is a strip stitch and glue. But it has no filets 
, I figured with a twelve panel hull it would look like a bengal tiger with all those filets.
What I did was to take a block plane and flush fit the joints and then glue them just like a striper . it seems to have turned out pretty well.
Ron
, I figured with a twelve panel hull it would look like a bengal tiger with all those filets. What I did was to take a block plane and flush fit the joints and then glue them just like a striper . it seems to have turned out pretty well.
Ron